Raptor DCP Motor Controller Ver. II

· 192 Volt Battery Pack
· FET High Side Switching
· 800 Amp Continuous
· 1200 Amp Peak
· Forced Air Cooling
· Internal Main Contact Control
· Internal Precharge Resistor
· For DC Series Wound Motors

This is a microprocessor based DC Motor Controller for DC Series Wound Electric Motors. The controllers uses FET's for high efficiency and low energy consumption on the part of the controller.

This version uses higher voltage FET's to allow the use of the controller on battery packs with a higher voltage. All Controllers have limits which must be followed.

See the Download Section for the Raptor Manual